Availability: Usually 1-3 weeks
By using a calibration bath, you can calibrate a wide range or sensors and probe sizes that may not fit into a traditional dry-well. The 140mm deep well makes it easy to carry out these types of calibration, along with bimetal and liquid in glass thermometers.
An RS-232 port allows the included Interface-IT software to be connected to make setup adjustments and capture the data. Other Fluke calibration software is also compatible with the 7102. In addition, the Fluke 7102 comes complete with built-in protection against over-temperature, 8 set-point memory storage, ramp-rate adjust and contacts to calibrate a thermal switch.
These micro baths are also CFC free and as there is no compressor, the micro baths are lightweight and easy to carry around. Along with this, because there are no moving parts, the calibrators are much more durable than similar products.
The two models available are listed below. Prices may vary depending on the model ordered, please contact us on 01923 442244 for a formal quotation:
- Fluke 7103-256: -30°C to 125°C
- Fluke 7103-TR-256: -20°C to 150°C
|Manufacturer Part Number||2645226|